Gardenia rotten root treatment

Clean up

Clean the Gardenia out of the pot

(author: good story source: Gardenia bar)

Cut off rotten roots

Cut off the rotten part of the Gardenia root with sharp scissors

(author: loofah source: stepping on flowers)

Disinfection

Put the trimmed Gardenia in carbendazim solution or high acid value solution for about 1 hour

(author: Mint cotton skirt source: hyacinth bar)

Dry in the shade

Take Gardenia out of carbendazim solution, put it in a cool place for about 1 day and wait for it to dry in the shade

(source: huicong.com)

Prepare basin soil

The soil preparation ratio is: rotten leaf soil: sandy loam: river sand = 2:2:1

Rotten leaf soil, peat soil, half of the garden soil

Or you can directly use the Clivia soil sold in the market

(author: binshandong; source: Gardenia bar)

Upper basin

At the bottom of the flowerpot, first put a layer of permeable things such as ceramsite, brick and cinder, and then fill it with nutrient soil to plant gardenia

(author: binshandong; source: Gardenia bar)

Future curing

The Gardenia just after the pot is not suitable for exposure to the sun. It should be placed in beiyangtai and other places. After the gardenia is adapted, it should be moved to the sunny place bit by bit

(author: Shuiyue Yitong Zen source: Gardenia bar)

Note:

Other woody plants, such as camellia, happiness tree, jasmine, osmanthus, woody rose, fortune tree and so on, can use the above methods to deal with rotten roots~

Treatment of rotten roots of Chlorophytum

Ventilation

If you think the Chlorophytum may rot, first put it in a place with good ventilation and sufficient light. If it still doesn't improve after a period of time, you need to prune the root

(source: Baidu knows)

Remove basin soil

Clean the Chlorophytum from the flower pot and wash the soil on the root of Chlorophytum with clean water

(author: witch77777; source: Baidu knows)

Pruning

The most important step is to cut off all rotten roots. It's better to cut off more than a little

(author: boiled water Mommy source: home in Shenzhen)

Disinfection

If you have Carbendazim and potassium permanganate at home, it is recommended that you disinfect. Soak the root of Chlorophytum in potassium permanganate for 1 ~ 2 hours, and then put it in a cool place until it is dry, that is, your hand doesn't feel wet after touching it

(author: rabbit_there; source: Baidu knows)

Basin soil

Chlorophytum does not have high requirements for soil, so ordinary garden soil can be used, or humus soil + river sand can be configured in the proportion of 5:1 or 5:2

(source: Baidu knows)

Upper basin

Plant the treated Chlorophytum into the basin soil, slightly compact the soil, pour water, and then put it into the room for maintenance without direct light

(author p; huang705354; source: Baidu knows)

Note:

Such as Clivia, Begonia, iris, columbine, Oxalis and so on, rotten roots can be treated in this way~

Treatment of rotten roots of hyacinth

Prevent rotten ball

1. When cleaning the seed ball, remember to keep the integrity of the seed ball. Don't hurt it at will. Once there is a small hole, disinfect it and dry it in the shade as soon as possible~

2. Clean up the dead roots and avoid the useless old roots from rotting and infecting themselves during hydroponics or planting

(author bean sprout TIR)

3. Keep the water level, keep the bottom of the root disk 1 ~ 3cm away from the water surface, and keep the sphere dry. In case of soil culture, avoid watering at the head, and the watering shall be carried out along the wall of the flowerpot

4. Dry thoroughly in the shade after soaking carbendazim. Because the sphere is wet after soaking carbendazim, if it is not well dried in the shade, it will also be in danger of mildew. Generally, hydroponics is better after a cool and ventilated day and night

5. The indoor temperature should not be too high, just keep the temperature at 15 ~ 18 ℃

Photography / cchyoulan

Seed ball mildew treatment

1. If it's just moldy, clean up the moldy place with a soft cotton swab or cotton cloth

2. Then apply some carbendazim for disinfection. Remember to dry in the shade after that

3. When it is completely dry, the soil culture can be covered with soil again, and the water culture can be put into the basin again

Seed ball decay treatment

1. Cut off all the rotten parts. Be sure to cut them off until all the rotten parts are invisible

2. Mix a lot of carbendazim or potassium permanganate solution according to the instructions, put the seed ball in and soak it for 2 ~ 3 hours

3. Take out the seed ball and dry it in a cool place

4. Put the seed ball back into the basin. If it is hydroponic, remember that the seed ball must not be in contact with water. If it is soil cultured, pay attention to watering. There must be no ponding and water cannot be poured on the seed ball

(author: out of tune oo0) source: hyacinth bar)

Note:

Like cinnabar, tulips, lilies and other bulbous plants, bulbous mildew and decay can be solved by the above methods~

Fleshy

Excise

After fleshy soil removal, use sharp scissors to cut off all rotten roots

Disinfection

The fleshy roots were disinfected in Carbendazim and then taken out to dry in the shade

Upper basin

After the succulent root system has dried in the shade, it can be directly put into the basin. The soil can be nutrient soil + perlite, 1:1

Note:

Most succulent plants can be solved in this way after rotten roots~

Margaret

Choose strong branches

Margaret is actually an annual herb. The rotten roots of herbs are not like woody plants. The best way is to use them directly for cutting. Therefore, take the branches on the plant that grow stronger and cut them off. Put it in a cool and ventilated place for 1 ~ 2 days

(source: Baidu knows)

Prepare pure vermiculite

Put pure vermiculite or pure perlite into the container for cutting, so the possibility of rooting will be higher. Before cutting, the perlite should be moistened with water

(source: Handmade customer)

Cutting

Insert the prepared cuttings into perlite or vermiculite. Then put it in a cool place for curing. Keep the medium moist. If the temperature is appropriate, it will take about half a month to take root

(author: chipmunk; source: stepping on flowers)

(Note: the pictures come from the Internet and the copyright belongs to the original author. Due to restrictions, some pictures cannot be found and the author has not been marked. If your rights and interests are infringed, please contact Huahua wechat qdxixi or qq1273160598 for deletion or copyright payment.)< span>